User's Manual

68
TOSIBOX
®
LOCK 150
INDUSTRY CANADA STATEMENT
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may
cause undesired operation of the device.
This radio transmitter IC: 25009-LOCK150 has been approved
by ISED to operate with the antenna types listed below with the
maximum permissible gain indicated. Antenna types not included in
this list, having a gain greater than the maximum gain indicated for
that type, are strictly prohibited for use with this device.
Lock 150: Wi-Fi monopole antenna max peak gain 2.0 dBi.
Under ISED regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved
for the transmitter by ISED. To reduce potential radio interference
to other users, the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication!
This equipment should be installed and operated with a minimum
distance of 20 cm between the antenna and the user or
bystanders.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes : (1) l’appareil ne doit
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
Le CI émetteur radio: 25009-LOCK150 a été approuvé par ISED
pour fonctionner avec les types d’antennes énumérés ci-dessous
avec le gain maximal admissible indiqué. Les types d’antenne non
inclus dans cette liste, ayant un gain supérieur au gain maximal
indiqué pour ce type, sont strictement interdits d’utilisation avec
cet appareil.
Lock 150: gain de crête maximum de l’antenne monopôle Wi-Fi de
2,0 dBi.
Selon les réglementations ISED, cet émetteur radio ne peut
fonctionner qu’avec une antenne d’un type et d’un gain maximal (ou
inférieur) approuvé pour l’émetteur par ISED. Afin de réduire les
interférences radio potentielles avec d’autres utilisateurs, le type
d’antenne et son gain doivent être choisis de manière à ce que la
puissance rayonnée isotrope équivalente (par exemple) ne soit pas
supérieure à celle nécessaire pour une bonne communication!
Cet équipement doit être installé et utilisé avec une distance
minimale de 20 cm entre l’antenne et l’utilisateur ou des tiers.