Installation Guide

Page 13 of 16
HD- SYSTEM OPERATING MANUAL Revision: 1/26/2018
HAND-HELD SHOWER OPERATION:
1. With the water on, push the diverter button down. Water will be diverted from the spout to the hand-
held shower.
2. To adjust the spray setting, turn the control ring located on the outer edge of the showerhead.
3. To divert the water back to the spout, simply turn off the water supply. When you turn the water back
on, the water will automatically flow out of the spout.
AIR SYSTEM OPERATION:
1. To operate the Air Massage System with the 3-speed variable motor, locate the push the button on the
side wall of the tub to turn on the system. It automatically starts at the highest setting. Push it again for
the medium setting. The third push is the low setting. The fourth push will shut off the system.
• Jets run for 20 minutes then automatically shut off.
• Blower is equipped with purging/drying cycle that will start 20 minutes after use and will continue
for several minutes.
HYDRO SYSTEM OPERATION:
1. To operate the Whirlpool System, locate the push the button on the side wall of the tub to turn on the
system. Push the button again to turn the whirlpool system off.
• Ensure the water level is above all the jets for the jets to function correctly.
• Damage to the jets and pump can occur if you attempt to operate the whirlpool system without
water.
• Adjust the direction of the jets by moving the “eyeballs” of the jets to the desired direction.
• Adjust the water flow (strength) of the jets by turning the “Chrome Ring” of the jet to the right
(reduce or shut off the flow of water) or left (increase the flow of water).
• The heat exchanger motor automatically maintains your water temperature when your whirlpool
system is operating.
• Water will drain out of the whirlpool system after each use.