Use and Care Manual

THE BLENDER

Assembly And Use

The Blender cup comes full size that means you are able to create large

batches for the whole family or bigger group of friends. The lid comes

with two handy features: dual-spout or strain-pour, and easy-vent at the

top for quick adding of ingredients. This is a fantastic feature, offering

great convenience when you need to add ingredients midway. The cross-

blade is the preferred blade choice.

Caution: Never run the motor continuously for more than 1 minute. The

motor has built-in thermal protection that will trip out. It may take longer

than one hour to reset the thermal circuit breaker. This is a safety feature

built into the power base. Large quantities may be prepared in smaller

batches with sufficient time between them for the motor to cool.

REPLACING BLADE GASKETS

A spare set of gaskets is included with the blender. Remove the old

gasket with a toothpick or similar sharp, but soft, tool. Observe the

tapered profile of the new gasket. The smaller edge goes down into the

groove of the blade base. Drop the new gasket into the groove, and then

press into place. Shaking the blade should not dislodge the gasket when

properly installed. Never use more than one gasket at a time. Additional

gaskets are available from our Customer Service department.

MICROWAVE PREPARATIONS

One of the most innovative features of your Miracle Blender is cooking

your food right in the cup. Once you have finished mixing or blending

your ingredients you can make soups, baby food, sauces and many

others by cooking or steaming in the microwave.

Start with blending your ingredients, remove the blade (no blade in

microwave), and replace it with the vented lid then put the cup into the

microwave for cooking. Always remove the cup with oven mitt.

CLEANING THE MIRACLE BLENDER

Just remember, there is only one component that you cannot wash: the

power base. All others, just place them in the top rack of the dishwasher

and it’s all done!

After washing a blade, check that the gasket (white ring) is still intact and

snugly fitted. Push it back into its groove if has come loose.

Should your power base need cleaning, just use a damp cloth to wipe it

down inside and out. You may remove stubborn stain or caked up food using

a damp cloth over an old toothbrush. The scrubbing should do the job!

IMPORTANT: MAKE SURE THE CORD IS UNPLUGGED

BEFORE CLEANING.