Installation Guide

10 ft. x 10 ft. Pond Skins

ITEM #EPDM1010

PACKAGE CONTENTS

PREPARATION

Before beginning installation of product, make sure all parts are present. Compare parts with package

contents list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or

operate the product. Contact customer service for replacement parts.

 Estimated Assembly Time: 2 hours

 Tools Required for Assembly: Garden hose, Shovel.

NOTES

Calculate the dimensions of your pond. Your pond should be at least 18 in. deep at the deepest point.

Allow for a 2 ft. overlap around the perimeter of the pond. The 10 ft. x 10 ft. liner will create a pond that is

approximately 4 ft. x 4 ft. x 18in.deep. It will hold approximately 180 gal. of water.

INSTALLATION INSTRUCTIONS

1. Use sand to mark the outline of your pond. Fig. 1

Fig. 1

Part

Description

Quantity

Liner

REMINDER

CALL 1-888-412-6001

BEFORE RETURNING TO STORE.

Questions, problems, missing parts? Before returning

to your retailer, call our customer service department at

1-888-412-6011, 8 a.m.-6 p.m., EST, Monday-Friday, or

email us at customercare@geoglobalpartners.com. Or

visit our website www.totalpond.com.

PAGE 1
0 ft. x 10 ft. Pond Skins® ITEM #EPDM1010 REMINDER CALL 1-888-412-6001 BEFORE RETURNING TO STORE. Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-888-412-6011, 8 a.m.-6 p.m., EST, Monday-Friday, or email us at customercare@geoglobalpartners.com. Or visit our website www.totalpond.com. PACKAGE CONTENTS Part A Description Liner Quantity 1 PREPARATION Before beginning installation of product, make sure all parts are present.
PAGE 2
. Dig out your pond and remove and debris or rocks that might damage your liner. Add approximately 2in. of sand to the pond area. The sand functions as a cushion beneath your pond liner. Spread the sand over the entire area and compact it. Fig. 2 Fig. 2 3. Open the liner and drape it across the pond area, making sure to leave at least 10in. of overlap around the perimeter of the hole. Begin to fill the pond with water, smoothing out any wrinkles as you do this. Fig. 3 Fig. 3 4.
PAGE 3
LIMITED WARRANTY All pumps and electrical products are warranted to the user against defective material and workmanship, under normal working conditions. This warranty period begins on the date of purchase by the original purchaser. All TotalPond® electrical products are warranted to the user against defective material and workmanship, under normal working conditions for 1 year from the date of purchase.