Instructions / Assembly

4
7. Adjust the flow control to the preferred setting. Fig. 7
Fig. 7
8. If the diverter valve was used, adjust the diverter valve to split the
flow between the fountain nozzle and the spitter as need. Fig. 8
Fig. 8
CARE AND MAINTENANCE
• Regular cleaning of the pump may be necessary depending upon the environment in which it is
operated. Clean the pump when it is visibly soiled or when a drop in performance is detected.
• Before cleaning, always disconnect the pump from the power source.
• Remove all parts from the pump and clean in warm, soapy water.
• Disassemble the front cover and remove the impeller cover to expose the impeller assembly.
Remove the impeller assembly by gently pulling on the impeller blades. Use a soft cloth or brush
to clean the impeller assembly and the inside of the impeller housing.
TROUBLESHOOTING
If the pump fails to operate:
• Check to make sure the power cord is plugged in and the pump is getting power.
• Check the pump outlet and any tubing, nozzle, spitters etc. for kinks or obstructions.
• Remove the inlet screen and/or pump cover, and impeller housing to expose the impeller.
Turn the impeller to ensure that it is not broken or jammed.
If the performance of the pump is not satisfactory or the pump does not flow evenly:
• Check to make sure the pump is completely submerged in water.
• Check to make sure the impeller and the housing are clean.
• Check to make sure the fountain nozzle is clean.
• Adjust flow control and diverter valve.
Fountain
nozzle
Diverter
valve
To spitter