Installation Guide

ITEM # N16100

Pond Nozzle Kit

PACKAGE CONTENTS

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package

contents list and diagram above. If any part is missing or damaged, do not attempt to assemble, install or

operate the product. Contact customer service for replacement parts.

• Estimated Assembly Time: 5 minutes

• No tools required for assembly.

ASSEMBLY

INSTRUCTIONS

1. Connect the two extension tubes with the coupler. Fig. 1

NOTE: Use the coupler if no spitters are to be used.

Fig. 1

Part Description Quantity

A Extension tube 2

B Coupler 1

C Adapter for 1/2” outlets 1

D Adapter for 3/4” outlets 1

E 3-tier fountain head 1

F Trumpet fountain head 1

G Waterbell fountain head 1

H Foam-jet fountain head 1

I Lower fountain head nozzle 1

J Diverter valve 1

Questions, problems, missing parts?

Before returning

to your retailer, call our customer service department at

1-888-412-6001, 8 a.m.-6 p.m., EST, Monday-Friday, or

email us at customercare@geoglobalpartners.com. Or

visit our website www.totalpond.com.

REMINDER

CALL 1-888-412-6001

BEFORE RETURNING TO STORE.

PAGE 1
ITEM # N16100 Pond Nozzle Kit REMINDER CALL 1-888-412-6001 BEFORE RETURNING TO STORE. Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-888-412-6001, 8 a.m.-6 p.m., EST, Monday-Friday, or email us at customercare@geoglobalpartners.com. Or visit our website www.totalpond.com.
PAGE 2
. Connect the extension tubes to the diverter valve. Make sure the arrow on the valve is positioned as shown and the diverter valve is connected as shown. Fig. 2 NOTE 1: Use diverter valve to simultaneously run a spitter and fountain head from one pump. A J Water flow A Fig. 2 3. For 1/2 in. tubing, connect the tubing onto the second output of the diverter valve. Connect the other end of the tubing to a spitter or other water feature. Fig. 3 NOTE: Tubing and spitter are NOT INCLUDED. 1/2 in tubing Fig.
PAGE 3
6. For the DD11210 and DD11330 pumps, use the 1/2” adapter to connect the pump to the extension tubes. For the DD11560 pump, use the 3/4” adapter to connect the pump to the extension tubes. Fig. 6 A A C D DD11210 & DD11330 DD11560 Fig. 6 7. For the MD11500, use the 5/8” adapter to connect the fountain head kit onto the pump. Fig. 7 Extension tube A 5/8” adapter MD11500 Fig. 7 CARE AND MAINTENANCE • Periodically disassemble the fountain head kit and clean the parts.