Owner's Manual

totemacoustic.com

Rear Connections

1. Aux 1

You can connect this analog input

to the analog output of yourTV,

cable box, satellite, game, turn table

or whatever device you’d like to

connect.

2. Phono/Line

For all modern electronics this

should be left in the “Line” position.

When connecting a turntable

equipped only with a Phono output,

set this to Phono.

3. Ground

This is used only with turntables

equipped with a ground cable.

4. Aux 2

This 3.5mm input can be used with

manyportable devices and

computers.

5. Sub out

This allows you to connect a Totem

Acoustic powered subwoofer to

your speaker to add thunderous

bass and enhance the low

frequency effect.

6. Digital In Optical

Sometimes referred to as Toslink or

SPDIF,this digital input allows the

useofanoptical

wire from your TV, cable box,

satellite, game, or whateversource

you’d like to connect.

7. Right Speaker Output

Connect the supplied speaker wire from here tothe right speaker’s input. Be sure to maintainthe polarity of the wire,

keeping the positive andnegative signals consistent to ensure best performance.

8. AC Input

The supplied power cord connects here, plug the otherside into a wall receptacle or power bar.

9. Power

This will turn the speaker on and off. Make sureto make all your connections before turning thespeaker on. You only

need to turn this switch on once, it will then go into standby mode when it is not in use.