Owner's Manual

9
totemacoustic.com
CONNECTING SOURCES
Use the appropriate audio cable to then connect your other sources. Totem has supplied an
Optical and Mini jack cable to cover most requirements.
If you are connecting a turntable, use the RCA inputs of Aux 1. If your turntable is equipped
with a ground wire as well, connect it to the grounding post on the s peaker.If the turntable has a
built in Phono Pre-Amp, set the switch located below the input to Line. If it does not, set it to
Phono.ATTENTION: Be sure to use the right setting and consult your turntable’s manual.
Using the wrong setting can damage your speakers a nd void the warranty.
CONNECTING A SUBWOOFER
A powered subwoofer can be easily added by connecting a single RCA cable from the Sub Out
on the Kin Play Mini to the Input on the subwoofer. Adding a Totem subwoofer will substantially
add to the bass capabilities of the system.
DECOUPLING
Totem recommends decoupling the loudspeaker with the supplied feet to break down cabinet
resonance for optimum results. Turn the speaker upside down and apply the adhesive backed
feet to the 4 corners of the cabinet.
ECO-FRIENDLY STANDBY M ODE
When no audio input has been detected for 60 minutes, the Kin Play Mini with go into Standby
mode. If the same audio signal that was playing when it entered standby mode returns, it will
wake. Kin Play Mini can also be “woken” by pressing the standby button on the remote.
VOLUME
Distortion is inevitable when the amplifier is pushed above its rated output level, which may
result in speaker damage. This type of damage constitutes abuse and may not be covered by
warranty. Be attentive to the instant distortion commences, turning the volume control down to
prevent speaker and/or amplifier damage.