Owner's Manual

totemacoustic.com

Use the appropriate audio cable to then connect your other sources. Totem has supplied an

Optical and Mini jack cable to cover most requirements.

If you are connecting a turntable, use the RCA inputs of Aux 1. If your turntable is equipped

with a ground wire as well, connect it to the grounding post on the speaker. If the turntable has a

built in Phono Pre-Amp, set the switch located below the input to Line. If it does not, set it to

Phono. ATTENTION: Be sure to use the right setting and consult your turntable’s

manual. Using the wrong setting can damage your speakers and void the warranty.

The AMP IN input bypasses the internal preamplifier so

features like volume and source select will not function.

This facilitates connecting and the functionality of

external streaming components. It is a 3.5mm jack so if

the streamer is not equipped with the same output, use

the proper adaptor as required. Once connected, the

amp will be controlled by the connected device.

A powered subwoofer can be easily added by connecting an RCA

cable from the Sub Out on the KIN Play Mini to the Input on the

subwoofer. Or, add the Totem LINK wireless transmitter to add the KIN

SUB 10 or Tribe Solution Sub without the need for wires. Adding a

Totem subwoofer will substantially add to the bass capabilities of the

system.

LINK Wireless Transmitter

When no audio input is detected for 60 minutes, the KIN Play Mini will go into Standby mode. It

can automatically wake by playing the last source that was used. It can also be awakened by

pressing the standby button on the remote or the far left or right sections of the display.

Totem recommends decoupling KIN Play Mini with the supplied feet to

break down cabinet resonance for optimum results. Turn the speaker

upside down and apply the adhesive backed feet to the 4 corners of the

cabinet.

Distortion is inevitable when the amplifier is pushed above its rated output level, which may

result in speaker damage. This type of damage constitutes abuse and may not be covered by

warranty. Be attentive to the instant distortion commences, turning the volume control down to

prevent speaker and/or amplifier damage.

CONNECTING SOURCES

CONNECTING A SUBWOOFER

VOLUME

AMP IN / CONNECTING A STREAMER

STANDBY AND AUTO ON

DECOUPLING

KIN PLAY Mini