Airbath Remote Synchronization Instruction

Table Of Contents

0GU5085, V.01

AirBath Remote Synchronization Instruction

Remove and restore power

This can be done by unplugging the blower/controller and re-connecting it. This can also be

done by switching off the circuit breaker and switching it on again.

NOTE: Using the On/Off button on the remote will not accomplish this step.

Remote

ON/OFF

INCREASE

BLOWER

DECREASE

BLOWER

MODE

LED

When is synchronization needed?

It is possible that the remote has lost synchronization when it does not respond properly.

Synchronization is needed when the remote is replaced or when the blower/controller is re-

placed.

Press and hold increase blower and decrease blower

The increase blower and decrease blower buttons need to be pressed simultaneously and held

down for 4 seconds.

NOTE: This must be done within 15 seconds after restoring power.

Repeat steps 1 and 2 if needed

After steps 1 and 2 are complete the remote should work correctly. If not repeat the steps.

PAGE 1
AirBath Remote Synchronization Instruction Remote When is synchronization needed? It is possible that the remote has lost synchronization when it does not respond properly. Synchronization is needed when the remote is replaced or when the blower/controller is replaced. ON/OFF INCREASE BLOWER 1 Remove and restore power This can be done by unplugging the blower/controller and re-connecting it. This can also be done by switching off the circuit breaker and switching it on again.
PAGE 2
Instrucciones para la sincronización remota del hidromasaje Remoto ¿Cuándo es necesario realizar la sincronización? ENCENDIDO/ APAGADO Es probable que el control remoto no esté sincronizado cuando no funciona correctamente. Es necesario realizar la sincronización cuando se reemplaza el control remoto o la turbina/el regulador. 1 2 Interrumpir y restablecer la alimentación eléctrica Esto puede hacerse desconectando la turbina/el regulador y volviéndolo a conectar.
PAGE 3
Instructions pour la synchronisation à distance du système AirBath Quand la synchronisation est-elle nécessaire ? Lorsque la télécommande ne fonctionne pas correctement, il est possible qu’elle ne soit plus synchronisée. La synchronisation est nécessaire lors du remplacement de la télécommande ou du ventilateur/contrôleur. 1 Couper, puis rétablir l’alimentation Cela peut être effectué en débranchant le ventilateur/contrôleur, puis en le rebranchant.