ABR626ST Instruction Manual

ABR & ABY Installation (continued)

Check Installation

AirBaths: Make sure the blower has ample unobstructed space to draw air and that the space is clear of dust and debris.

All bathtubs: Make sure the bathtub is level and supported by the feet or wood base or mortar sub-floor and not the flange lip.

Clean Up

 When cleaning after installation, do not use abrasive cleaners, as they may scratch and dull the surface. Use warm water and a

liquid non-abrasive detergent to clean the surface.

 Stubborn stains, paint or tar can be removed with isopropyl (rubbing) alcohol. Rinse well and dry with a soft, clean cloth.

 Do not use metal scrapers, wire brushes or other metal tools.

Trial Operation

 Close the drain.

 Fill the bathtub.

 Check for leaks from the air jets (AirBath only).

 Check for leaks from the drain.

 Check plug voltage and verify the AirBath activates when the “ON” button is

pressed. Note: The remote may need synchronization. Cycle power to the AirBath. Within

15 seconds, press and hold the Up Blower and Down Blower buttons for 4 seconds.(AirBath

only - see Owner manual)

 Check operation. (AirBath only - see Owner manual)

 After operation, drain the bathtub and run the Automatic Drying Cycle. (AirBath only

- see Owner manual)

ABF Installation with access under the floor

Preparation

 Clean, level and prepare the floor for installation.

 Place the unit in the exact installed position on the floor. Be sure the tub is resting on the bottom supports and not the acrylic.

 Determine the location of the drain pipe on the floor by taking measurements of the drain and waste location underneath the unit.

(Drain and waste locations will vary by model.)

 Carefully place the unit on a blanket, cardboard, or other clean protective surface so that the unit is properly supported.

 Clean the drain hole area in preparation of setting the drain. The area should be dry and free of any debris.

Drain

Jet Fitting