ABR626ST Instruction Manual

Finish decking and seal bathtub

ABR & ABY Installation (continued)

Connect the drain to plumbing

 Follow local codes

 Make sure that connections are tight to avoid leaks.

Make electrical connections (AirBath)

 All electrical connections must be made by a licensed electrician and

meet local codes. Refrain from using extension cords.

 Class A, 15 amp Ground Fault Control Interrupter (GFCI) with grounding

is required.

 The controller, blower and GFCI must be accessible.

With Flange

Silicone

With Tile-in Flange

 Pre-drill pilot holes through the tile-in flange.

 Mount with screw or nail to studs.

 Finish tiling the bathtub deck and be sure to seal the

bathtub lip to prevent leaks.

Silicone

Finished Surface

Optional Under Mount

 See spec sheet to determine if this is available

 Cut finished surface to desired dimensions.

 Dry fit to the bathtub.

 Temporarily mark on the bathtub the edge of the opening of the finished surface.

 Remove the finished surface and apply silicone to the bathtub (underneath the

finished surface location).

 Replace the finished surface and secure it.

 Add and/or remove silicone as desired.

 Make sure the finished surface is not supported by the bathtub and is secured per

local codes.