Airbath User Manual

ENGLISH

OPERATING INSTRUCTIONS

1) Fill the Bath with Water

Fill the tub to your preference�

NOTE: Be careful not to overﬁll the bath as the water level will rise when the bather enters the bath�

2) Turn the Air Massage On

Press the ON/OFF button to begin the Air Massage�

The massage begins on an intensity level that is 60% of the maximum

intensity�

3) Change Massage Intensity

• Press and hold the Up Blower button to increase the blower speed�

Release at the desired speed�

• Press and hold the Down Blower button to decrease the blower speed�

Release at the desired speed�

4) Change Massage Modes

Press the Mode button to change between the massage modes� The

modes cycle in the following way:

Normal > Oscillate > Pulse > Normal

NO TE: The controller is designed to shut the blower off after 20 minutes

of continuous running� To restart the blower, press the On/Off button�

MASSAGE MODES

Massage Mode 1: Oscillating Massage Mode :

Oscillating mode gradually cycles through the

intensity settings giving a wave-like, soothing

massage�

Massage Mode 2: Pulsating Massage Mode:

Pulsating mode cycles the jets from the minimum

intensity level to the maximum intensity level, giving a

powerful, penetrating massage�

To Activate: Press the LED button

• Pressing the LED button and holding for one second will turn the

light off�

Changing the Chromotherapy Mode

• The rst press will turn the light on the rst mode, the second will turn

the light on the next mode, etc�

• Chromotherapy modes: White, Rainbow Cycle (Slow), Rainbow Cycle

(Fast), Turquoise, Blue, Magenta, Red, Orange, Yellow, Green,

Rainbow Cycle (Slow)�

Chromotherapy Light