Installation Guide

ManualsBrandsTOTO ManualsBathtubsTOTO Clayton 66" Acrylic Soaking Bathtub for Drop In Installations with Center Drain

Notes

1. Ensure that the unit is the correct model and color and that ex-

pected parts are present.

2. Inspect for shipping damage. Any damage claims must be

made to the carrier immediately. Do not install the bathtub if

any finish damage is revealed.

3. For AirBaths make sure that all air hoses and electrical con-

nections are properly connected.

4. Observe all installation procedures and local plumbing codes

and regulations.

5. Provide an appropriate, clean and level sub-floor.

6. Ensure adequate space for the bathtub and provide properly

dimensioned framing.

7. Do not remove protective plastic until necessary. Cover the

bathtub with cardboard for additional protection.

8. Do not place ladders, tripods, building material, waste or other

equipment in the bathtub.

9. See spec sheet for dimensional information.

10. Power Supply Specification (AirBath only):

60 Hz, 120 V, 1050 W

ABA & ABY Installation

Prepare Location

Remove old bathtub, if necessary.

Prepare sub-floor and level, if necessary.

Construct wooden frame.

Use template to ensure correct framing.

For AirBaths an access panel of at least 16” x 20” wide, or per

local code, must be installed at the blower end of the unit for

maintenance or servicing.

Locate and install rough plumbing.

All framing must be square and plumb.

The bathtub cannot be hung by its lip. The bathtub weight

must be transferred solely through the feet.

Install Drain (Sold Separately)

Install the drain according to the

manufacturer’s directions and local

codes. The template is designed for

bathtubs using Toto drains.

Note: Take care not to scrape or mar the bathtub while installing

the drain.

Test Fit

Test fit (dry fit) the bathtub in the frame to make sure the bathtub

will fit.

Seat the bathtub into the framing.

Leave a 1/8” (3 mm) gap between the flange and the framing.

Mortar should be used to secure and level the bathtub.

Use two people to move the bathtub.

Assure the bathtub is level in both directions for proper water

drainage.

Any attached wood base should remain attached.