Installation Guide

To the installer

Be sure to provide the customer with the Installation manual.

Fill out the necessary warranty information on the back off the Owner manual (for AirBaths).

ABF Installation without access under the floor (continued)

Install Bathtub

Apply a generous bead of adhesive or silicone (such as GE 5040 Silicone II) to the bottom of the

tub supports.

Apply a bead of tub and tile caulk (such as GE 7000 Silicone II Paintable Silicone) around the

edge of the base.

Carefully set the tub into position over the drain body.

From inside the tub thread on the drain body top. Do not over tighten.

Be sure the tub is resting on the bottom supports and not the acrylic.

Complete Installation

Fill the tub with water to the overflow and drain the tub while inspecting the waste connections below the floor for leaks.

With the bathtub now in place wipe off any excess tub and tile caulk around the bottom edge of the bathtub where it meets the

floor.

Run a bead of tub and tile caulk around the bottom edge of the bathtub where it meets the floor. Wipe off any excess caulk with a

wet cloth.

Replace the stopper.