Installation Guide

4
ENGLISH
TOILET TANK FILL VALVE INSTRUCTIONS
Cyclone
®
/ G-Max
®
/ E-Max
®
/ Power Gravity
®
WARNING! DO NOT USE IN-TANK BOWLCLEANERS
The use of high concentration of chlorine or chlorine-related products can
seriously damage ttings in the tank. This damage can cause leakage and
property damage. TOTO shall not be responsible or liable for any tank t-
ting failure or damage caused by the use of in-tank bowl cleaners.
INSTALLATION
1. Shut OFF water supply to toilet.
2. Flush toilet and remove remaining water from tank with a sponge.
3. Remove the water supply connection at the ll valve.
4. Remove old ll valve and use damp sponge to clean hole in tank.
5. Place new ll valve inside tank hole.
6. Thread mounting nut onto ll valve shank and tighten nut.
Note: DO NOTOVERTIGHTEN. Be sure to install ll valve in a
position that does not interfer with the trip lever operation.
7. Connect water supply to ll valve shank and hand tighten only.
Note: DO NOTOVERTIGHTEN. These are plastic parts.
Never use pipe dope on any water supply connection.
8. Attach rell tube to ll valve nipple and clip other end of rell tube
to the overow pipe.
9. Turn water supply ON and check for leaks outside the tank.
Note: As water lls the tank, water is also directed into the over-
ow tube via the rell tube. This additional ow of water is
critical to relling your toilet’s bowl. Once the water stops
lling the tank, some residual drops of water may drip from
the ll valve. This is NORMAL as these drops will subside.
WATER LEVEL ADJUSTMENT
Depending on the manufacturing plant, you may have one of two of
the following ll valves.
WATER
LEVEL
Type A
Type B
For Type A ll valve, refer to water level (WL) setting
marked on the inner wall of the tank. Allow the water to ll
the tank. Turn the adjustment screw clockwise in the (+) direc-
tion to increase the water level height. Turn the adjustment
screw counter-clockwise in the (-) direction to decrease the
water level height. Flush the toilet to verify the correct water
level. Adjust as necessary.
WL
Top of Overow Tube
For Type B ll valve, there are no water level adjustments.
THE FILL VALVE HAS BEEN PRESET AT THE FACTORY.
WL
Top of Overow Tube
OPERATION (NOTE TO OWNER)
You have chosen a TOTO product that is superior in quality and
craftsmanship. Our toilet ushing systems are the best in the indus-
try. To insure that your toilet is performing correctly, always ush the
toilet with a full stroke of the trip lever to activate the ushing cycle.
A full stroke will guarantee that you are ushing with the power of a
TOTO.
If you need advice on your installation, feel free to contact one of our
Technical Support members at the number below.
TOTO USA, Inc. 1155 Southern Rd, Morrow, GA 30260
Tel.: [phone] • Fax [phone]
www.totousa.com
Printed in USA ©TOTO USA Inc.