Installation Guide

Installation (continued)

Completing the Finished Wall

• After connecting the drain to the trap add the finished wall.

• Install tile or any finished wall material to provide a minimum gap of 2 mm (1/16”) for contraction

and expansion. Seal with silicone.

• Install the faucet trim according to the manufacturer’s instructions.

Tile In Flange Models

FBY1515, FBY1525 and FBY1715

Drop In

Silicone

Finished Surface

• Cut finished surface to desired dimensions.

• Dry fit to the bathtub.

• Temporarily mark on the bathtub the edge of the opening of the finished surface.

• Remove the finished surface and apply silicone to the bathtub (underneath the finished surface

location).

• Replace the finished surface and secure it.

• Add and/or remove silicone as desired.

• Make sure the finished surface is not supported by the bathtub and is secured per local codes.

Flat Rim Models

FBY1500, FBY1510,

FBY1550, FBY1700 and

FBY1800

Silicone

Ceramic/Stone/Tile

Water resistant

Gypsum board

(green board)

Bathtub Maintenance

WARNING: Do not use acidic or alkaline base products to clean the bathtub. Damage to

the enamel surface may occur.

• Be sure to clean the bathtub after each use. Dirt may stain the bathtub if left for long periods.

• Use neutral detergent, a soft cloth and a sponge. Follow only the installation instructions for your

particular model/installations.

• Before using the bathtub place a small amount of cold water into the bathtub. Then add hot wa-

ter. If the hot water is 80 ºC (176 ºF) and used directly the bathtub can become damaged.

• Avoid water containing sulfur. This will discolor the bathtub.

Under Mount Models

FBY1500, FBY1550, FBY1700 and

FBY1800