Installation Guide

8
ENGLISH
TROUBLESHOOTING
Problem Possible Cause Solution
The product
does not oper-
ate when push-
ing the switch
to ON.
The battery has been
inserted incorrectly.
Reinsert the battery, making sure it is
correctly positioned in the +/- posi-
tion.
The battery needs
replacing
Insert a new battery into the
battery encasement.
Water does not
discharge
properly or, no
water discharg-
es
from the wand,
even though
the
device is ON.
A manganese battery has
been installed instead of
an alkaline battery.
Replace the battery with an
alkaline battery.
The battery needs
replacing
Insert a new battery into the
battery encasement.
The wand is clogged up.
Clean the wand
The strainer inside the
tank is clogged up.
Clean the strainer
Water leaks
from the tank.
The tank has not been
pulled out all the way.
Pull the tank out all the way until it
clicks into place.
Water leaks
from the wand
after
use.
The wand has not been
stored properly into the
storage position.
Check to make sure the
protruded end of the wand has
been inserted into the hole on the
main unit and has been folded in
the direction of the arrow for proper
storage.
Dimensions
(main unit)
When stored: 2.65” x 1.8” x 5.1” (67 x 46 x 130mm)
When in use: 2.65” x 1.8” x 11.7” (67 x 46 x 298mm)
Total product weight Approximately 0.55 lbs (250g) (including the battery)
Discharged water
volume
Standard: 0.28 Ounce/sec (8ml/sec) (when the alkaline battery
is new)
Soft: 0.32 Ounce/sec (9ml/sec) (when the alkaline battery is
new)
Tank capacity 0.19 Quarts (180ml)
Power source 1 AA alkaline battery
Battery life (at 20°C) Approximately 50 applications (for use with an alkaline bat-
tery with up to 0.17 Oz/Sec (5ml/sec) of discharged water
volume).
Accessories included Carrying pouch (1), AA alkaline battery (1)
* Repair of this product requires the expertise of a trained technician. Do not attempt to
repair a malfunctioning product without consulting a Service Center.
SPECIFICATIONS