Installation & Assembly

ManualsBrandsToto ManualsBathLibella Electronic Faucet

ENGLISH

INSTALLATION PROCEDURE

Testing After Installation

Open

Stop Valve

ill. 1

Turn on the water supply at the stop valves and

inspect all the connections for any leaks (see ill. 1).

Place hand under the sensor to activate.

For 10 sec model: water will stop after 10 seconds

while your hand is under the sensor.

Water will stop when you remove your hand.

CARE & CLEANING

PERIODIC MAINTENANCE

when cleaning rosnes eht hctarcs ton oD IMPORTANT!

the spout (see ill. 2).

h thectarcs yam taht slairetam gninaelc yna gnisu diovA

spout surface.

s edulcni taht tnegreted ,redwop gnihsilop esu reveN

coarse particles, thinners, benzene, acids, alkaline

detergents, or nylon scrub brushes, as they can damage

the surface of the spout.

d softenepmad a gnisu ti epiw ,ecafrus eht naelc ylefas oT

cloth with diluted dishwashing detergent and dry it with

another soft cloth. If this does not adequately clean the

surface, wipe the area with a neutral detergent and wet cloth.

ill. 2

Sensor Area

Outlet

Check your faucet at least once a month for the following potential problems and to do the

following maintenance procedures:

Inspect for Leakage

Check all water connections for signs of leakage.

Tighten the Spout

If the spout is loose, tighten the hexagonal nut underneath the spout for deck-mounted

models.

To tighten the Helix Wall-Mounted Spout:

1. Unscrew the escutcheon, tighten the three screws securing the mounting bracket to the

wall.

2. Reinstall escutcheon.

To tighten the Gooseneck Wall-Mounted Spout

1. Turn off the water supply at the stop valves and disconnect the spout connecting hose

from the controller.

2. Remove the spout from the mounting bracket by removing the set screw on the bottom

of the spout base.

3. Tighten the set screw on the back of the spout, then reinstall the spout on the mounting

bracket.

4. As required, ensure the set screw on the mounting bracket and mounting nuts behind

the sink/wall (refer to “Install the Spout” section) are tight.

For 20 sec model: water will stop after 20 seconds.

Spout and Sensor