Installation & Assembly

4
ENGLISH
INSTALLATION PROCEDURE
Installing the Lavatory
1) Clean the mounting surface with a
soft clean cloth.
* NOTE: Do not over-tighten the wing nuts. Over-tightening may damage the lavatory.
2) Apply a continuous bead of sealant (not
included) or the sealing gasket (shown
below).
Cleaning Cloth
Lavatory
Lavatory
Sealing Gasket (optional)
3) Insert the
threaded rods
into the mount-
ing holes at the
bottom of the
lavatory.
Screw-
driver
Threaded
Rod
4) Place the lavatory
onto the counter-
top.
5) Place the washers onto
the threaded rods and
install the wing nuts* .
Wing Nut
Threaded Rod
Installing the Drain Fitting
1) Slide the gasket onto the drain
fitting.
Gasket
Drain
Fitting
2) Install the drain fitting into the
lavatory outlet.
Drain Fitting
Lavatory
Sealant
3) Apply a continuous bead of
sealant to the underside of the
drain fitting and
verify there are
no leaks.
Washer
4) Install the mounting nut and tail
piece section.
Adjustable
Wrench
Drain Nut
Slip Washer
Gasket
Tail Piece Section
and Washer
CAUTION