Installation Guide
5
ENGLISH
6) The supply stop should be installed per
the supply stop instruction at the location
shown in the Before Installation section.
Flush the water line briey to ensure
removal of debris. Connect exible supply
hose to supply stop.
CAUTION: Hand-tighten only.
Open the supply stop, checking for leak-
age. Slightly re-tighten if necessary. The
water supply pressure should be 20 to 80
psi static.
7) NOTE: No ballcock / ll valve adjustments
are needed. The water will automatically
stop at proper level.
Flush the toilet several times. Check ap-
per valve for proper operation. Make sure
that chain is not tangled and apper arm is
in its proper position.
8) Install the toilet tank lid onto the toilet tank
top.
9) Install the toilet seat onto the toilet bowl
(see Illustration 7). (Top Mount Bolt Set is
included with the bowl). Insert the rubber
bushing nuts into the bowl seat holes.
NO TE: Remove the existing seat if neces-
sary.
Place the seat on the bowl and rotate the
hinge unit into place while holding seat
down on the bowl. Fasten and tighten
the bolt from the top with a screwdriver.
Replace the bolt cap and the lower lid (if
necessary).
Seat Bolt
Rubber
Brushing
Nut
Ill. 7
MAINTENANCE INSTRUCTIONS
Fill Valve Replacement Procedure
1) Shut off the water supply to the toilet.
2) Flush toilet and remove remaining water from tank with a sponge.
3) Remove the water supply connection at the ll valve.
4) Remove old ll valve and use damp sponge to clean hole in tank.
5) Place new ll valve inside tank hole.
6) Thread mounting nut onto ll valve shank and tighten the nut.
NO TE: Do not over-tighten. Be sure to install ll valve in a position that does not
interfere with the trip lever operation.
Ill. 6
Water
Inlet
Washer
Coupling
Nut
Trim Plate
Flexible
Supply
Hose (not
supplied)
Valve
Nut
Compression
Valve
Nipple
INSTALLATION PROCEDURE