Use and Care Guide

20 21
Operation
Using the Remote Control
Basic Operations
Press a button on the remote control; a beep sound when the top unit receives the signal. When ushing and opening/closing the toilet seat with the remote control
Cleansing
*1
Flushing
Drying
*1
Stopping
Opening
and closing
■
Water pressure adjustment
You can select from 5 levels of water
pressure.
([ - ] Softer, [ + ] Stronger)

When you press the cleansing buttons
(Rear, Rear soft, Front, Wide front),
the position returns to the standard
position (3rd position).
If you do not want to return the wand
to the standard position.(Page 43)
■
Wand position adjustment
You can select from 5 levels of wand
position between the front and the rear,
using the [
▲ ] and [ ▼ ] buttons.

When you press the cleansing buttons
(Rear, Rear soft, Front, Wide front),
the position returns to the standard
position (3rd position).
If you do not want to return the wand
to the standard position.(Page 43)

Functions that operate
when a button is pressed
during"Rear cleansing",
"Rear soft cleansing", "Front
cleansing" or "Wide front
cleansing".
"Warm air drying"
Dries your rear.
"Front cleansing"
Serves as a bidet for ladies.
"Wide front cleansing"
Gently cleanses a wide area.
"Rear cleansing"
Cleanses your rear.
"Rear soft cleansing"
"Full ush"
Cleanses your rear with soft embracing water ow.
Performs a full ush.

Up to 33 ft (10 m) of toilet paper (single)
"Opening and closing the toilet seat"
Opens and closes the toilet seat.
"Light ush"
Performs a light ush.

Up to 10 ft (3 m) of toilet paper (single)
Note

Sitting back on the toilet seat makes it easier to adjust the wand position and to reduce splashing.
"Stopping"
Stops the
operation.
"Menu, Return" button
(Page 22)

Adjust settings

Return to the previous menu
"Temperature adjustment"
button
(Page 24)

Adjust temperatures
"Power ON/OFF" button

Pressing it about 3 seconds or longer
turns the power on/off.
•
If the remote control is locked to
prevent theft (Page 17, Procedure2-2)
Display screen

The display goes out when no buttons
on the remote control are pressed for
about 60 seconds or more.
Remote
control
back side
You can store your preferred "Wand position," "Water pressure," and "Warm water
temperature" settings.
 To store a setting
 While cleansing is in progress, set your preferred "Wand position," "Water pressure," and
"Warm water temperature," and then press and hold
or for 2 seconds or longer.
 To use
 Press
or , and then press the button for the cleansing you want to use.
■
Wand CLEAN
Cleans the wand with "ewater+"

The wand can be automatically
cleaned when you use the
cleansing functions (Rear
cleansing,Front cleansing,
etc.).
(Page 18)
"Oscillating cleansing"
The wand moves back and forth
to cleanse your rear thoroughly.
"Pulsating cleansing"
Cleanses with the water
pressure pulsating between soft
and strong.
The cleansing setting changes each time
the button is pressed
OFF+
■
Personal setting lock
Low battery warning LED
(Page 59)
*1 This cannot be used if the seat sensor is not working. Sit so your skin is in direct contact with the seat sensor (page 11).