Use and Care Guide

44 45
Maintenance
Maintenance
Top Unit
WARNING
Always unplug the power plug from the
outlet before maintenance or inspection.
(Failure to do so may cause electric shock or
malfunction, resulting in a breakdown.)
*1 Except when using "Wand cleaning" or "Bowl unit cleaning".
*1

After the power plug is inserted, the toilet lid does not open
automatically for about 10 seconds (because it is preparing for
operation). Open and close by hand.
Top Unit
(Approximately daily)
Do not use a dry cloth or
toilet paper on plastic parts.
(May cause damage.)
Top unit
Bowl unit
The "Power"
LED goes off.
Lit Off
Soft cloth soaked
in water
Toilet paper
Dry cloth
Nylon scrubbing brush
(May cause damage.)
Unplug the power plug.
Wipe with a soft cloth that has been soaked in water and wrung-out thoroughly.
■
For heavy dirt
󱡢
Wipe with a soft cloth soaked in diluted, neutral kitchen detergent, and then wipe with a soft cloth soaked
in water.
Insert the power plug.
󱡢
The "Power" LED lights up.
Attention!
󱛡
This product is an electric appliance.
Be careful not to let water seep inside or leave detergent in the gap between the
top unit and bowl unit.
(May damage plastic parts or cause a malfunction.)
󱛡
When using a toilet cleaner to clean the toilet, rinse it off within 3 minutes and leave the toilet seat and toilet lid open.

Wipe off any cleaner that remains on the bowl unit.

(If vapor from a toilet cleaner enters the top unit, it may cause a malfunction.)
󱛡
Do not push or pull the covers around the wand with undue force.
(May cause damage or malfunction.)
󱛡
Wipe the back surface of the toilet seat and the toilet seat cushions with a soft cloth tightly wrung out with water.
(Otherwise adhesion of dirt may result in discoloration.)
󱛡
Please wipe any water droplets so that none remain on the toilet seat.

(Failure to do so may cause malfunction of the seat sensor or the
Flush button on the upper right corner of the toilet
seat.)
1
2
3
 Neutral kitchen
detergent
Paint thinner
Benzene
Powdered cleanser
Power Plug (Approximately once a month)
Dry cloth Wet cloth
1
Unplug the power plug and wipe it
with a dry cloth.
2
Insert the power plug.
•
The "Power" LED lights up.
WARNING
●
Periodically remove dust from the
blades and other parts of the power
plug.
•
Unplug the power plug and wipe it
with a dry cloth.
●
Fully insert the power plug.
●
When unplug the power plug, hold the
main body of the power plug.
•
Pulling the power cord may damage
the power plug or power cord.
Power Plug
For safety, unplug the power
plug before maintenance.
*1