Use and Care Guide

60 61
Reference
How to Freeze Damage Prevention (Dynamic Mode)
This method runs the water for the bowl unit and top
unit automatically at a fixed interval in order to prevent
freezing.
■
How to Set
(Page 42)
󱛡
Switch "Anti freezing" to "ON" with the remote control.
While Anti freezing is set to ON, it works as follows.
• The "Power" LED flashes.
• The toilet flushes at intervals of about 10 minutes.
• About 1.69 oz (about 50 ml) of water comes out from
near the wand at intervals of about 5 minutes.
(The wand remains retracted.)
When the ambient temperature is likely to drop to 32°F (0°C) or lower, take measures to prevent freezing.
Attention!
󱛡
When the ambient temperature is likely to drop to 32°F (0°C) or lower, do not use the energy saver feature.
(May damage the product.)
󱛡
Warm the bathroom or take measures against freezing so that the ambient temperature does not drop below 32°F (0°C).
󱛡
Before starting to work, set "Auto flushing" (Page 32) and "Auto open/close" (Page 34) to "OFF".
<Power>
The toilet ushes at intervals
of about 10 minutes.
Water comes out from near the wand
at intervals of about 5 minutes.
Freeze Damage Prevention
What to Do?
Long Periods of Disuse
How to drain the water
Remove the shutoff valve cover, and then
close the shutoff valve.
󱡢
The water supply stops.
Install the shutoff valve cover.
Press "Full ush" button on the remote control to drain the tank.
Press "Wand CLEAN" button.
•
The wand cover opens.
(Release the pressure from the water supply pipe.)
Unplug the power plug.
1
CAUTION
Do not remove the water lter
drain valve while the shutoff
valve is open.
(Otherwise, water may leak out.)
2
3
4
5
If the toilet is in a location you will not visit for a long time, drain the water.
(The water in the tank may cause malfunctions or become contaminated and cause skin irritation or other problems.)
(May cause freezing and damage to product.)
Shutoff valve
cover
Opening / closing
tool (accessory)
or flat-head
screwdriver
To the next page