Use and Care Manual

Basic Operations
Opens and closes the toilet seat.
* The mode changes between [SOFT] (Flickering) and [REAR] (Lit) each time
the button is pressed.
To store a setting
While cleansing is in progress, set your preferred wand position, water pressure and
water temperature, and then press and hold " " or " " for 2 seconds or longer.
To use
After " " or " " is pressed, please push the button used for cleaning.
* The wand position and water pressure LED's will light up for about 10 seconds
displaying the programed personal settings. Then the water temperature display
will also show the programmed personal setting.
1 2
1 2
[
SEAT OPEN / CLOSE ]
Stopping
Stops the operation.
[STOP]
Perform a full flush.
[FULL FLUSH]
Perform a light flush.
[LIGHT FLUSH]
Cleanses your rear.
[REAR]
Serves as a bidet for women.
[FRONT]
Opening and closing
Drying
Dries your front and/or rear.
[DRYER]
You can store your preferred wand position, water pressure and water temperature
settings.
[PERSONAL SETTING LOCK 1] [PERSONAL SETTING LOCK 2]
Cleansing
Cleanses your rear with mild water
pressure.
[SOFT]
Flush
If you cannot operate with the remote control
Operation is also possible using
the buttons on
the Washlet control panel.
The wand moves back and forth to wash
your rear thoroughly. The setting
changes between "ON" and "OFF" each
time the button is pressed. You can use
this function whenever you feel like it.
Functions that operate when a button is pressed during
"REAR", "SOFT" or "FRONT" cleansing.
[OSCILLATING]
The wand position can be adjusted to the
front or rear.
("▲" : Moves to the front, "▼" : Moves to
the rear)
[POSITION]
Washes with the water pressure pulsat-
ing between soft and strong. The setting
changes between "ON" and "OFF" each
time the button is pressed. You can use
this function whenever you feel like it.
[PULSATING]
The water pressure strength can be
adjusted for cleansing functions such as
REAR.
("+" : Stronger, "–" : Softer)
[PRESSURE]
Washlet control panel
*