Use and Care Manual

Fully open
to the right
Fully open
to the left
Tip
14
If the lid is not either fully up or full down when the NEOREST is plugged in,
it will stop at that same inbetween position the next three times it is opened
or closed. Please confirm there is nothing holding the lid in an inbetween
position before inserting the plug. Then push on the remote control.
When the plug is inserted, the soft light will flash for somewhere between 10
seconds to a minute. During this period, the seat sensor A is initializing. The
auto lid open/close feature will not function until the sensor is done initializing,
but the seat and lid can still be operated using the remote control.
:Insert the power plug into the outlet
3
Push on the remote control.
2
3
While the time is flashing, push
on the remote control to change
the hour.
While the time is flashing, push
on the remote control to change
the minute.
4
5
The time can now be changed.
Push to set to 15
Push to set to 10 AM
Push
The new time is set.
The new time is shown on the remote control
display.
When the remote control receives a signal
from the top unit, it will give out a beep.
Before Using
The time flashes on the remote control display.
If the clock is flashing and none of the buttons
on the remote are pushed for more than a minute,
the display will return to normal. You can only
set time while the display flashes. To get the
display flashing again, press the set button again.
10:00
AM
10:15
AM
10:15
AM
12:00
AM
Flashing
AM10
is displayed
is displayed
The new time
is displayed
15
Tip
Tip
Tip
Confirm
Confirm
Confirm