Use and Care Manual

Tip
Tip
About the NEOREST seat sensors
When the remote control batteries dead
Push on the top unit
Use flush button on the top unit controls.
The NEOREST flushes a full flush.
Remote flush
6 seconds must pass after a flush before the NEOREST will respond to a command to flush again.
Seat sensor A is used to detect a person
within 1 ft. (30cm) of the NEOREST.
26
[AUTO LID OPEN/
CLOSE IS OFF]
When the room temperature is over 86°F (30°C),
the sensor cannot detect a person.
Under direct sunlight, erroneous detection may
cause the lid open.
If the restroom door is open, seat sensor A may be
able detect a person outside the door.
: Flushing
5
There are two flush modes: Remote flush Auto flush modes.
On the remote control display shows
AUTO[ LID OPEN/CLOSE IS OFF]
The NEOREST uses 2 seat sensors.
FLUSH
Push or
Full flush
(For solids)
Light flush
(For liquids)
AM
AUTO LID OPEN
Sensor B
Sensor A
POWER FLUSH CLEANSING
FFO/NOFFO/NO
REAR
ON/OFF
FRONT
Top unit controls
The setting has been changed.
The automatic open/close
feature is disabled. The clock
display resumes.
[Current time]
Amenities
Tip
Confirm this!
To restore the automatic
open/close feature,
repeat the
steps above.
It uses changes in temperature for detection
Sensor B is used to detect a person sitting
on or standing in front of the NEOREST.
It uses an infrared beam for detection
The remote control can be used to flush the NEOREST (even if the auto flush feature is ON).
The NEOREST flushes either a full or light flush.