Specification Sheet
SPECIFICATIONS
• Water Use 1.0 GPF/3.8LPF
• Flush System Tornado Flush
®
• Min. Water Pressure 8 psi (flowing)
• Water Surface 6-7/8" x 9-3/4"
• Trap Diameter 2-1/8"
• Rough-in 12"
• Trap Seal 2-1/8"
• Warranty One Year Limited Warranty
• Material Vitreous china
• Shipping Weight CST614CUFGT20 110lbs
SW2034T20 16.0lbs.
• Shipping Dimensions CST614CUFGT20
32"L x 20"W x 17-3/4" H
1
x
28-3/4" H
2
SW2034T20
23" 1/2"X 20 1/2" X 9"
• See Spec sheet SW2034T20 for Washlet details
MW6142034CUFG
Carlyle
®
II 1G
®
/ Washlet
®
+ C100 One-Piece Toilet - 1.0 GPF
SS-01153 v.03
Ph: (888) 295-8134 | Fax: (800) 699-4889 | www.totousa.com | © TOTO USA
INSTALLATION NOTES
Back-to-Back Toilet Installations:
TOTO recommends the use of a nationally listed,
double sanitary tee-wye only, in vertical waste stacks,
in accordance with the stipulations noted in the
majority of nationally recognized plumbing codes.
These dimensions and specifications are subject to change without notice
Double Sanitary Tee / Sanitary CrossDouble Combination Wye / 1/8 Bend
YES NO
Important Note:
Back-to-Back Toilet Installations:
TOTO USA, Inc. recommends the use
of a nationally listed, double sanitary
tee-wye only, in vertical waste stacks,
in accordance with the stipulations noted
in the majority of nationally recognized
plumbing codes.
!
*GCFI Outlet Min.
12" off floor
*The 3-prong cord on the Washlet is on the right side and is 4' long.
The GFCI outlet needs to have120V, 10amps.
18 13/16"
[478mm]
5 1/2"
[140mm]
20 7/8"
[531mm]
11 15/16"
[303mm]
7 3/8"
[188mm
]
15 3/8"
[390mm]
1 1/2"
[38mm]
5/16"
[8mm]
Elongated
*GCFI Outlet Min.
12" off floor
*The 3-prong cord on the Washlet is on the right side and is 4' long.
The GFCI outlet needs to have120V, 10amps.
18 13/16"
[478mm]
5 1/2"
[140mm]
20 7/8"
[531mm]
11 15/16"
[303mm]
7 3/8"
[188mm]
15 3/8"
[390mm]
1 1/2"
[38mm]
5/16"
[8mm]
Elongated
To maintain adequate wall gap between the back of
the tank and wall, mount the floor flange at a nominal
12” rough-in distance.
Ultra-low high efficiency toilets require a system with
adequate supplemental flows from other water usage
fixtures and a 4” ID drainline with minimum 2% slope
and maximum linear runs of 60ft.