Washlet Owner's Manual

Energy Saver
Trouble Please check
Ref.
Page
The Energy saver LED
does not light up
●
Did you unplug the power plug or was there a power outage?

The "Energy saver" LED on the main display may go off when the power is
turned on even if the energy saver feature is "ON".
(It will turn on within about 24 hours since the setting is retained.)
-
The timer energy saver
feature is not working
●
Did you replace the remote control batteries?

"Timer energy saver" may be canceled when the batteries are replaced.

Set the timer energy saver again at the time you want to start it.
30
The auto energy
saver+ or auto
energy saver feature
is not working
●
Because the function takes several days learning the usage conditions before
starting energy saver, the amount of energy saving may be low, depending
on the frequency of use.

Check the energy saver setting.
●
Did you replace the remote control batteries?

The settings may be canceled when the batteries are replaced.

Set them again.
28
30
Deodorizer
Trouble Please check
Ref.
Page
The deodorizer
seems to be not
working
●
Is "Deodorizer" set to "OFF"?

Set to "ON".
●
Even after sitting down, you do not hear operation sounds.

Sit back on the toilet seat.
●
If you hear an operation sound when you sit on the toilet seat.

Clean the deodorizing filter.
46
-
33
A strange odor is
emitted
●
Are you using an air freshener or deodorizer that you purchased separately?

Doing so may reduce the effectiveness of the Washlet deodorizer or cause
strange odors.

Remove the air freshener or deodorizer.
-
The auto power deodorizer
feature is not working
●
Is "Auto power deodorizer" set to "OFF"?  Set to "ON".
●
It starts about 10 seconds after you stand up from the toilet seat.
46
-
Sanitary
Trouble Please check
Ref.
Page
The soft light, bowl light
and CLEAN indicator
do not light up
●
Is the "Soft light", "Bowl light" and "CLEAN indicator" setting "OFF"?

Set to "ON".
●
If the "CLEAN indicator" LED is not lit, it is time to replace the component that
generates "ewater+". (Replacement will be charged) Consult the installer,
seller, or TOTO customer service (see contact information on the back cover).
48
-
Pre-mist and
after-mist do not
work
●
Is "Auto bowl CLEAN" set to "OFF"?

Set to "ON".
●
The following functions do not work when the toilet seat is open.

Is "Seat/lid" of "Auto open/close" set to [Seat•lid]?

You can change it to "Lid".
●
The pre-mist does not work for about 90 seconds after the after-mist has fi nished.
44
42
-
The pre-mist sprays
out spontaneously
●
Because the body sensor can detect movement through the wall or door in
front of the toilet, the "Auto bowl CLEAN" function may cause the toilet to pre-
mist even when you are outside of the bathroom.

You can switch "Auto bowl CLEAN" to OFF.
44
Troubleshooting
64
M08036_1_EN.indb 64M08036_1_EN.indb 64 8/18/2017 11:32:26 AM8/18/2017 11:32:26 AM