Installation Guide

34 35
Maintenance
Maintenance
Gap between the Main Unit and the Toilet Bowl
Gap between the Main Unit and the Toilet Lid
Gap between the Main Unit and the Toilet Bowl (Perform monthly)
You can remove the main unit to clean the top of
the toilet bowl and the bottom of the main unit.
Soft cloth soaked in water Toilet paper, etc.
(May cause damage.)
1
[USA]
Unplug the power plug.
[Asia, Oceania]
Switch the breaker on the distribution board to OFF.
2
Remove the main unit.
Do not pull the unit with undue force (because the water supply hose and power cord are attached).
•
Base plate
Bolt
Main unit removal button
Pull the main unit toward you
while pressing the button.
3
Clean the gap.
Wipe with a soft cloth soaked in a diluted, neutral kitchen detergent, and then wipe with a
•
soft cloth soaked in water so that no detergent remains.
4
Mount the main unit.
Base plate
Click
Align the center.
Push the main unit until
a click sound is heard.
After mounting, check that the main
unit does not detach even when pulled.
CAUTION
Push the main unit fi rmly onto
the base plate until a click
sound is heard.
5
[USA]
Insert the power plug.
[Asia, Oceania]
Switch the breaker on the distribution board to ON.
6
Check the POWER LED on the Washlet control panel.
POWER LED Status
Lit Mounting is OK
Off
Press "Power ON/OFF" and check
that it lights up
Flickering
Not mounted properly
➝
Mount
again
35
Maintenance
Between the main unit and the toilet lid (Perform monthly)
The toilet lid can be removed for thorough
cleaning.
Soft cloth soaked in water Toilet paper, etc.
(May cause damage.)
1
[USA]
Unplug the power plug.
[Asia, Oceania]
Switch the breaker on the
distribution board to OFF.
Removing and Reinstalling
A
B
C
D
E
Hinge
Hinge
Tab
Pin
Hold with
both hands
2
Remove the toilet lid, and
then remove the main unit.
(Page 34)
: Pull the left side outward.
: Disconnect the hinge from the tab and
pull up.
: Disconnect the right side.
3
Wipe with a soft cloth that has
been soaked in water and
wrung out thoroughly.
4
Reinstall the toilet lid.
: Join the pin and the hinge on the right
side.
Slightly tilt the toilet lid to the front.
: While pulling out the left side,
: Mount by joining the hinge with the
tab.
* Be careful not to pinch your fi ngers.
5
[USA]
Insert the power plug.
[Asia, Oceania]
Switch the breaker on the
distribution board to ON.
6
Open and close the toilet lid
to check the mounting, and
then mount the main unit.
(Page 34)