Installation Guide

To Install Helix and Libella Wall-Mounted Models (ill. 5):
NOTE: The addition of a 2 x 4” stringer behind the spout installation location is highly
recommended.
STEP 8
2 x 4
Stringer
2 x 4
Studs
Finished Wall
5/8” Hole for
spout
Holes for screws/
anchors
ill. 5
3. Feed the supply tube and sensor cord through
the 5/8" (16 mm) hole in center.
Place spout against wall and fasten securely with
the provided screws.
t until ekcarb eht ot noehctucse eht netsaF .4
hand-tight.
ill.6
Escutcheon
5
ENGLISH
INSTALLATION PROCEDURE
To Install Gooseneck Wall-Mounted Models (ill. 8, 9 & 10):
noitacol derised eht ta eloh )mm 92( ”8/1-1 a llirD .1
for the mounting bracket. Place the mounting
bracket
through a hole in the wall with the set
screw hole located at 12 o’clock. Mark the
location of the set screw hole on the wall and
remove the mounting bracket.
For sheet metal surface: Drill a 3/16” (5 mm) hole at the marked location.
For
a drywall/hollow wall surface: Drill a 1/4” (6.5 mm)
hole at the marked location, and install
the included wall anchors.
ill.7
Ø 1-1/8"
15/16"
Ø 3/16” (sheet metal surface)
Ø 1/4” (drywall/hollow wall)
ill. 8
Hole for set screw/machine
screw and wall
anchor
Hole for mounting bracket
To Install Helix Wall-Mounted Models (ill. 6):
3.
Place mounting bracket against wall and fasten
securely with the provided screws.
4. Pass the hose and sensor cord through the
mounting bracket, slide the spout base over the
mounting bracket and tighten the set screw to
secure the spout to the mounting bracket.
Mounting
Bracket
Set Screw
1. Place mounting template on wall at desired
location and mark all holes. Drill a 5/8" (16 mm)
diameter hole at the spout mounting location
(center) for the supply tube and sensor cord to
pass through.
2. For fastening to wood , drill three (3) pilot holes
7/64” (2.7 mm) in diameter at marked locations.
To Install Libella Wall-Mounted Models (ill. 7):
NOTE: Confirmation of wall strength is highly recommended before drilling.
For fastening to drywall or tile, drill three (3) holes
3/16” (5 mm) in diameter and insert anchors until
flush. Tap lightly with a hammer if needed.
NOTE: The addition of a 1 x 6” or plywood bracing behind the mounting location is highly
recommended for drywall/hollow wall installations. The overall maximum wall
thickness is 2” (50 mm).
NOTE: Drill bits (not supplied) for hard materials may be required.