Installation Guide

8
ENGLISH
When the inlet screen is clogged, the flow rate will decrease. Decreased flow rate can
lead to insufficient power generation, which will deplete the backup battery prematurely.
Cleaning the screen (see ill. 1 & 2):
1. Turn the water off at the stop valves.
2. Remove controller cover and quick fastener.
3. Remove controller from hose adapter.
4. Remove screen and clean it with a brush.
5. Reinstall the cleaned screen.
IMPORTANT!
If flow regulator (or flow regulator assembly
for TELC103R-###E) falls out, reinstall it in the
correct orientation (O-ring side facing screen)
as shown. Otherwise, product will not
function properly.
6. Reinstall the controller into the hose adapter
until fully seated, and secure it with the
quick fastener.
7. Reinstall cover, securing it with the screws.
8. Open stop valves and check all connections.
Cleaning the nozzle (see ill. 3):
1. Remove the nozzle from the spout
with the supplied tool.
2. Clean the nozzle with a soft brush
to remove any dirt from the screen.
3. Re-install the nozzle in the spout.
Power supply
Hydropower Generation (self-powering power supply)
Sensor Detection Range
5-1/8”~ 7-7/8” (130 ~ 200mm)
Sensor is self-adjusting.
Water Supply Connection
Minimum : 15 psi (100 kPa) (Flowing)
Maximum : 80 psi (551 kPa)
Water Supply Pressure
G1/2 compatible with ½ NPSM
39 ~ 110°F (4 ~ 43.3°C)
Inlet Temperature range
Ambient Temperature
32 ~ 104°F (0 ~ 40°C)
Humidity
Max. 90% RH
0.09 gpc
(0.36 Lpc)
0.18 gpc
(0.67 Lpc)
0.19 gpc
(0.72 Lpc)
Flow Rate
Duration
10 seconds 20 seconds
SPECIFICATIONS
PERIODIC MAINTENANCE
Cleaning the Inlet Screen and Nozzle
Volume per cycle
1.0 gpm 0.5 gpm 0.35 gpm
10 seconds 20 seconds
0.11 gpc
(0.44 Lpc)
Open
Close
Spout
Nozzle
Key
ill. 3
Spout
Nozzle
Brush
ill. 1
Screen
Flow Regulator
Remove Quick Fastener
Hose Adapter
ill. 2


Flow regulator for TELC103R-D##E
models is assembled inside an adapter.
Install assembly with correct orientation.


UP