Installation Sheet

NOTE: Before installing the product, be sure to thoroughly ﬂush the supply pipes of dirt and

debris. Shut off the water supply at the stop valves after ﬂushing.

Install the Controller

See the rough-in dimension page to determine the proper

location for the controller.

Remove the screws on the front of the controller cover and

pull to remove.

Mount the bracket on the wall. If necessary, use wall anchors

(see ill. 1).

IMPORTANT!

Be sure to install controller in the correct orientation as shown. Otherwise, product will

not function properly.

From the top, place controller into the hole in the bracket. From below the bracket, fasten

the large nut to secure the controller (see ill. 2).

ENGLISH

INSTALLATION PROCEDURE

To Install Deck-Mounted Models (ill. 4):

Secure the spout to the countertop with the included

bracket and hexagonal nut. Make sure that the spout

is mounted with the tip directed towards the center

of the basin.

Install the Spout

SPOUT

ill. 4

Connect the water supply line to the inlet adapter (see ill. 3).

NOTE:

If using a thermostatic valve (sold separately), please refer to its installation manual for

details.

ill. 2

ill. 3

Nut

Spout connecting

hose

Sensor cord

Gasket

Mounting Bracket

Mount Bracket

Nut

Angle Stop

Supply Hose

Mount Bracket

Nut

ill.1