Installation Sheet

INSTALLATION PROCEDURE

Hex wrench

Escutcheon

Joint tube

Pipe connection

Cap

Control stop

9. Fasten the sensor top cover to body

assembly with the supplied screws

and hex wrench.

The Flush Valves are preset for ﬁxture volume as marked on

the valve carton. The valve does not require adjustment for

variation in water pressure within its operating range.

11. To set the Flush Valve for proper operation, open the

control stop completely by using the adjusting screw.

12. Activate the Flush Valve several times.

13. In the case of excessive ﬂow rate, gradually adjust the

control stop towards the closed position using the

adjusting screw, until there is suitable water ﬂow into the

ﬁxture.

14. The cap for the control stop should be placed after ﬁnal

adjustments have been made.

15. Tighten the cap ﬁrmly with a wrench.

WARNING: Do not open the control stop to the point where the ﬂow from the Flush Valve exceeds

the ﬂow capability of the ﬁxture. In case of a valve failure, the water must not overﬂow

from the ﬁxture.

10. Before the supply water is turned on,

be sure all water leaks are eliminated

by tightening all the pipe connections.

NOTE: If for any reason it becomes necessary

to remove the control stop, make sure

the water is shut off at the main supply

valve.

ENGLISH