Dimensions Guide

Inlet supply 1” NPT
Inlet Supply
1” NPT
4-9/16”
(115mm)
3-3/16” (81mm)
** ADA 2010 Section 609
Grab Bar
** Ø1-1/4”~2”
(32~51mm)
** 1-1/2” (38mm)
* Min.11-1/8” (282mm)
11-1/2” (292mm) (w/o cutting)
** 33”~36”
(840~915mm)
ADA Grab bar combination
Max. 29”(737mm)
(for Ø1-1/4” Grab bar)
Max. 28-3/4”(730mm)
(for Ø1-1/2” Grab bar)
Max. 28-1/4”(718mm)
(for Ø2” Grab bar)
4-3/4”±1/2”
(120±13mm)
1-1/2”
NPSM
7”
(178mm)
Min. 2-1/4” (57mm)
** Min. 1-1/2”
(38mm)
* Check local codes
4-1/4”
(108mm)
TET1GA
ECOPOWER
®
Toilet Flush Valve, 1.6 GPF
#SS-01162, v.02
Ph: [phone] | Fax: [phone] | www.totousa.com | © TOTO USA
These dimensions and specifications are subject to change without notice
SPECIFICATIONS
*Water pressures over 80 psi are not recommended for most plumbing
fixtures. Check your local plumbing code for details.
• Material Bronze casting
• Power supply ECOPOWER
• Sensor detection time Factory setting at six
(6) seconds minimum
• Sensor detection range Self-adjusting to
environment
• Discharge quantity Preset to 1.6 GPF/
6.0 LPF
• Operating temperature 32°-104°F (0°-40°C)
• Water supply pressure 15 psi - 125 psi*
• Water supply connection 1" NPT
• Warranty Three year limited
TET1GA, TET1LA
TEU1GA, TEU1LA
TEU1LA
33-1/2"
(850mm)
15°
Max 19-11/16”
(Max 500mm)
DIAGRAM
INSTALLATION NOTES
For commercial applications only.
Warning: Failure to properly adjust angle stop to
the appropriate level can potentially cause property
damage.
For detailed installation instructions, please refer to
the installation manual.
Max flow rate to be used with
TET1GA___________: 1.6 GPF
Confirm with local codes and standards for floor drain
requirement. Adjust control stop for proper flow rate
to the fixture.