Installation Guide

TET6UA
#SS-01255, v.01
Ph: [phone] | Fax: [phone] | www.totousa.com | © TOTO USA
These dimensions and specifications are subject to change without notice
SPECIFICATIONS
• Material Bronze casting
• Power supply EcoPower
• Sensor detection time Factory setting at six
(6) seconds minimum
• Sensor detection range Self-adjusting to
environment
• Discharge quantity Preset to 1.0 gpf/
3.8 lpf
• Operating temperature 32°-104°F (0°-40°C)
• Water supply pressure Min: 35 psi (flowing)
Max: 125 psi (static)
• Water supply connection 1" NPT
• Warranty Three year limited
4-1/4”
(108mm)
3-3/16”
(81mm)
** ADA 2010 Section 609
* Check local codes
Inlet Supply
1" NPT
Min. 2-1/4”
(57mm)
4-3/4”±1/2”
(120±13mm)
4-9/16”
(115mm)
1-1/2”
NPSM
7”
(178mm)
* 27”
(686mm)
Inlet Supply
1” NPT
TET6LA
TET6GA
33-1/2"
(850mm)
20°
Max 21-1/4”
(Max 550mm)
*Water pressures over 80 psi are not recommended for most plumbing
fixtures. Check your local plumbing code for details.
INSTALLATION NOTES
For commercial applications only.
Warning: Failure to properly adjust angle stop to
the appropriate level can potentially cause property
damage.
For detailed installation instructions, please refer to
the installation manual.
Max flow rate to be used with
TET6UA___________: 1.0 gpf
Confirm with local codes and standards for floor drain
requirement. Adjust control stop for proper flow rate
to the fixture.
EcoPower
®
Ultra High-Efficiency
Toilet Flush Valve, 1.0 GPF
PRODUCT DIMENSIONS