Installation Guide

4
INCLUDED PARTS
(Continued)
TLK01101U TLK01102U
TLK01103U
Hose Unit (TLK01403U)
I-shaped nippleConnecting hose 16.4’ (5m) Hose clamps (1)
Sub-Tank Unit (TLK01401U)
Soap Intake
Sub-Tank Y-shaped nipple
Connecting hose 16.4’ (5m)
Hose clamps (6)
Special Order
TLK01106U
TLK01107U
ENGLISH
5
1. Make sure to leave at least 4-3/4" (120 mm)
of space between the soap dispenser and
the faucet to prevent accidental activation.
2. Leave 3-1/8" (80 mm) of space maximum
from the inside edge of the sink to the spout
installation hole to ensure that any residual
soap drips from the dispenser spout into the
sink bowl.
INSTALLATION PROCEDURE - Positioning
Positioning the Dispenser
Positioning the Tank
Sink
Auto Soap Dispenser
Faucet
(2) The distance from the
soap dispenser to the
edge of the sink to be
3-1/8" (80 mm) maximum
Hole for installing
the dispenser
[1"～1-3/32" (25～28 mm)
in diameter]
(1) Space between the dispenser
and the faucet to be
4-3/4" (120 mm) minimum
 Install the tank within 31.5 inch from the upper face of the counter. It also should not exceed the
height of the upper end of the controller.
It cannot be installed on the counter or on the lower level.
If it is installed beyond this range, the following troubles may occur. Less water spouts and the
soap does not foam.
 The length of the hose connected to the spout is 6.0 ft. Install the controller so that the hose can
be connected to the controller.
Spouts
Controller
Less than 55'' (1400 mm)
(Height of controller:
14'' (350 mm))Less than 59'' (1500 mm)
(Unit: Inch)
* The dimensions in the figure are limited to when
the tank is installed on the left end.
If actual dimensions exceed those in the figure,
cords and hoses may not reach.
Tank
* For a spout-to-spout distance
of 25.6'' (650 mm)
Less than 31.5''
(800 mm)
Controller installable range
(* 59'' (1500 mm))
ENGLISH