Owners Manual: TS170E

2
34 -104°F (2 - 40°C)
Water Supply
Pressure
Minimum pressure
Maximum pressure
Supplied Water Temperature
Water Quality
Ambient Temperature
Water Supply Connection
20 psi (0.14MPa) (flowing pressure)
125 psi (0.86MPa) (static) Check local building code
Less than 185°F (85°C)
Water that meets National/Primary drinking water regulation
1/2” NPT
Depending on the model, some specifications may differ.
Specification
Humidity
Flow Rate
Maximum 90% RH
Max. 2.5 gallons per minutes (9.5L/min)
Before installation
● If the water supply pressure is higher than 125psi (0.86MPa), you should buy a
reducing valve to reduce the pressure to the range of 0.2-0.3MPa.
To use the faucet comfortably, the recommended pressure is about 30-45 psi
(0.2-0.3MPa).
●To prevent being scalded due to malfunction, the cold water supply pressure must
be higher than the hot water pressure, or you can make them equal. In addition,
if you increase the pressure of the hot water, it still must be lower than that of cold
water supply side.
●To prevent being scalded due to wrong operation, it is recommended the hot water
supply temperature is 140°F (60°C).
▪ Observe all local plumbing codes.
▪ Make sure water supply is shut off.
▪ Read these instructions carefully to ensure proper installation.
▪ Check to make sure you have the following parts indicated below.
●For ease of water flow adjustment and inspection with tools, you should prepare an
extra stop valve.