Owners Manual: TS170E

Installation Procedure
Caution
1
Clean the cold/hot water pipes
①Put pipe sealing tape around the pipe
Adapter.
②Screw the adapter into water supply pipe
firmly.
③Screw the spout into the pipe
adapter and
④Face the spout right to the floor and fix it
fimly with setscrew, using an Allen wrench.
2 Installation of Showerhead
Wall Spout needs to be connected with a Renesse volume control valve for Shut-off
and a Renesse Thermostatic Mixing Valve for temperature control.
●Setscrews are for preventing the product
from falling . Tighten it very cautiously.
●Tighten the setscrew, with the spout
being pressed on the wall.
pipe sealing tape
Pipe Adapter
with O-ring
Finished Wall
O-rings
3/16 “ (5mm)
RECOMMENDED:
(standard gap)
Before installation
dirt and debris in the cold/ hot water supply pipes must be washed out.
Caution
● Be sure to wind the seal tape around
the adapter and tighten it very firmly
NOTE:
Confirm this
gap carefully.
PRESS IT ON THE WALL.
Allowable range:
0 - 3/8”
(0 to 10 mm)
Finished Wall
Finished Wall
Finished Wall
MAX. 1” (25 mm)
HOLE
When a hole is made for
wall spout water supply
pipe, MAKE SURE that
the hole is not more than
1” (25mm).
Set screw
Allen Wrench
Spout
4