Installation Sheet

3
ENGLISH
INCLUDED PARTS
Faceplate *
Escutcheon Handle Assembly *
Temperature Limit Stop
(short)
Set Screw & Hex Wrench
Valve with Plaster Guard
TSST
* Actual product may vary in appearance depending on the model.
TS220T shown.
Check to make sure that all these parts were included in your packaging:
REQUIRED - NOT
INCLUDED
CARE & CLEANING
Your new shower trim is designed for years of trouble-free performance. Keep
it looking new by cleaning it periodically with mild soap, rinsing thoroughly
with warm water and drying with a clean, soft cloth. Do not use abrasive
cleaners, steel wool or harsh chemicals, as these will dull the finish. Failure to
follow these instructions may void your warranty.
INSTALLATION PROCEDURE
1. Confirm that the valve has
been installed properly.
NOTE: The finished wall
surface should be between the
min and max markings on the
plaster guard. See the TSST
installation manual for further
information.
Plaster Guard
Thermostatic
Valve
Finished Wall
Max 95mm (3-3/4”)
Min 65mm (2-1/2”)