Owners Manual: TS416E, TS624E, TS626E, TS630E

4 5
ENGLISH
ENGLISH
* Actual product may vary in appearance depending on the model.
TOOLS YOU WILL NEED
BEFORE YOU START INSTALLATION
INSTALLATION PROCEDURE
Pipe Adapter
1/2” NPT Nipple
Finished
Wall
3/8” to 7/8”
Illustration 1
Adjustable Wrench
Pipe Tape
Pipe Adapter
with O-ring
Set Screw
Hex Wrench
Spout *
N OTE: Thoroughly clean and remove all debris from the water supply pipe
before beginning your installation. This will prevent clogging in the spray
outlet.
IMPORTANT!
For proper installation, a nipple with a 1/2” NPT male thread extending
between 3/8” and 7/8” beyond the finished wall is required. If this is already
present, proceed to step 3.
NOTE: The hole for the nipple should be not larger than 1” in diameter.
1) Measure from the supply elbow
inside the wall to the finished wall
surface to properly size the nipple.
2) Wrap pipe tape around one end
of the nipple and fasten it to the
supply elbow.
3) Remove the set screw and slide the
pipe adapter out from the spout,
taking care not to damage the
o-ring.
4) Wrap pipe tape around the other
end of the nipple, then thread
the pipe adapter onto the nipple,
taking care not to damage the
o-ring.
5) Slide the spout onto the pipe
adapter, taking care not to damage
the o-ring.
6) Secure the spout with the set
screw.
 Observe all local plumbing codes.
 Make sure the water supply is shut off.
 Read these instructions carefully to ensure proper installation.
 TOTO
®
reserves the right to update product design without notice.
 Check to make sure you have the following parts indicated below: