User's Guide

360° Microphones
Mute LED
Power LED
Bluetooth LED
1
• Remove the top cover of S100A conference speaker and
snap in C100 conference camera module.
• Plug the included power adapter into a power outlet and
connect the other end to S100A
• Press and hold [ ] on the top of the speaker for 1
second to turn S100A on and 2 seconds to turn it off.
Turn on SC100
• Plug the included USB cable into your computer and
connect the end with the type-C connector to SC100.
• Select S100A as the default microphone and speaker
source. Select C100 as the default camera source.
Connect SC100 to your computer
2
Bluetooth
S100A
• Press and hold [ ] for 2 seconds until the Bluetooth LED
on S100A begins flashing. You will hear connection guidance
voice prompts.
• Enable Bluetooth on your Bluetooth device.
• Select S100A from the list of available Bluetooth devices to
connect.
• You will hear a successful connection message from S100A.
• Tap [ ] to disconnect with connecting Bluetooth device.
3
Connect SC100 with a Bluetooth Device (Audio Only)
• Tap [ ] while calling to mute or unmute the microphone.
Mute/Unmute
4
• Snap C100 into tripod adapter and attach it to the included
display mount.
• Mount C100 on top of the display and adjust the camera
view to correct position.
• Plug the included USB cable into either USB port at the
bottom of S100A and connect the other end with the
type-C connector to C100
• Select S100A and C100 as the default audio and video
source on your computer
Mount C100 on Display
internal
S100A
internal
C100
User Guide
Warranty Card
USB Cable(3m) x1
USB Cable(2m) x1
Tripod Adapter
Power Adapter
Display Mount
VIDEO
CONFERENCE
SYSTEM HD
What’s in the Box
FCC Statement
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
Installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including Interference
that may cause undesired operation.
ISED Regulatory Compliance
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L’exploitation est autorisée
aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
RF Exposure Compliance
This equipment complies with FCC/IC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance
20cm between the radiator and your body.
Cet équipement est conforme aux limites d’exposition aux radiations FCC/IC
établies pour un environnement non contrôlé.
Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm
entre le radiateur et votre corps.
EU Compliance
VuPoint (Europe) Company Limited declares that the equipment complies
with Directive 2014/53/EU.
Full declaration text available at:
www.toucansolution.com/pages/certificate
©2022 VUPOINT SOLUTIONS, INC. All Rights Reserved.
The Toucan logo and Toucan are trademarks or registered trademarks of VuPoint Solutions
Inc. in the United States and other countries. The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth SIG, Inc. Product names, logos, brands and other
trademarks referred to herein are the property of their respective trademark holders. All
trademarks remain the property of their respective holders, and are used only to describe the
products or services being provided. These trademark holders are not affiliated with VuPoint
Solutions, Inc. They do not sponsor or endorse VuPoint Solutions, Inc’s products or services.
VuPoint Solutions, Inc. (USA):
710 Nogales Street, City of Industry, CA 91748
VuPoint (Europe) Company Limited:
Innovation Center, Longbridge Technology Park,
Longbridge, Birmingham B31 2TS
For additional info, visit our website at www.toucansolution.com
Conference Speaker
S100A
Conference Camera
C100
Thank You
for Purchasing
For detailed product information, set up procedures and FAQ’s
please visit our website: www.toucansolution.com or scan the QR code.
USB3.0 Port Maximum Output Rating: DC5V/500mA
Getting Started
Press and hold to turn S100 on/off
Power On/Off
Tap to increase volume
Volume up
Tap to reduce volume
Volume down
Mute
Mute microphone
Tap to mute or unmute microphone
Voice guidance
Press and hold 10s to turn voice guidance on/off
Bluetooth
Connect with new Bluetooth device
Press and hold to enter Bluetooth pairing mode to connect
with a new Bluetooth device
Disconnect or reconnect with Bluetooth device
Tap to disconnect or reconnect with a paired Bluetooth device
successful
connection
Getting to know your
Video Conference System HD SC100