Instructions / Assembly

9 10

Remove optional inner temporary adhesive

for camera positioning and use leveler to

align and balance back plate. You can use a

pencil or Position Sticker (included) to mark

placement before adhering to your wall.

Attach conduit and cover on back plate to

determine the conduit’s length. Afterwards,

remove the conduit from back plate.

Refer to Option 1 to mount camera to wall with

adhesive or Option 2 to mount camera to wall with screws.

STEP 2 Mounting the camera’s back plate

After using the Leveler to adjust

the balance of the plate, adhere

the Positioning Sticker to mark

the center of the plate.

Remove and flip plate to remove

outer adhesive from back plate

for a more stable placement of

the camera to the wall.

Align back plate with the

Positioning Sticker on the wall

to center the plate.

1 2 3

OPTION 1 Mounting with adhesive

Before installation, make sure the power switch is OFF or disconnect power at fuse.

Refer to “What Is Included” in Section 2 for part installation for the steps below:

STEP 1 Socket installation

Install Smart Socket to fixture.

Attach USB Cable to

Smart Socket.

Thread in light bulb.

Reattach lamp

shade if necessary.

Remove USB cover. Before

installing the socket into light

fixture, disassemble the lamp

shade if necessary.

Screw lamp shade back in and

drag out USB cable through the

shade then adjust Silicon Pipe

from USB cable to protect cable.

4. Toucan Installation