www.iotgizmo.
Requirements 2.
Step 1: Remove Old Switch/Dimmer ! Caution Electrical Circuits with 120V AC are HAZARDOUS and could kill people by electrocu- tion. Only certified electrician shall perform the replacement or installation of Smart Dimmer. It is essential to turn-off the breaker supplying power to the switch being replaced with smart dimmer Figure A. Shows a typical residential electrical wiring of a switch.
Red Dimmer Red wire (Line-Out/Load) connects to Black-Wire going to the light fixture Green Dimmer Green Wire GND connects to ground wires in the electrical panel box. Step 3: Step 3-A: Power ON Circuit Breaker to continue installation of the iotGizmo Touch Dimmer Once the power is turned on by flipping the Circuit breaker you will see bottom White-LED blinking and lights turns ON. It means dimmer is connected right and is ready to control lights.
Step 4: Power ON Circuit Breaker-Energizing the Smart Dimmer Download iotGizmo app from the app-store for iOS and play-store for Android smart phones. Register at the website and create a login/password, there will be a confirmation email sent to the registered login-emailD. Click OK on the link and your credentials will be established for cloud-server access to control smart devices. Login to the app with login/password you have used to register. You shall see the following screen.
LTE 9:30PM 95 % LTE 9:30PM Wi-Fi Configuaration Wi-Fi Configuaration Configuring device for My WiFi Configuring device for My WiFi Please enter Wi-Fi password ad click start button to finish device configuaration Type Wi-F- password here Please aprove the Wi-Fi “iotGizmo” Wants to Join Wi-Fi Network “My WiFi”? Cancel LTE 95 % Select ‘Join’ and if the process is successful once shall see the right side screen.
LTE Once the IotGizmo Dimmer is added to your device list as shown below, you can control the dimmer from your smartphone.
Step 6(A): Manual Dimmer operations - Touch Dimmer The dimmer can turn the light on or off by touching anywhere in the middle where the LEDs indicate the dimmer level. iotGizmo Dimmers always remember the previous brightness level and illuminate your lights to the previous setting. If you want to change the brightness level, slide finger or thumb up or down the middle over the LED indicators to set the dimmer to a desired level.
Manual Operation of Single Dimmer: A Multi-dimmer always remembers previous brightness level of single dimmer and illuminate your lights to the previous setting. B If you want to change brightness level, slide thumb on touch panel in the clockwise direction to increase or decrease brightness. C If you want to turn light ON/OFF simply touch the panel, preferably in the center area.
Step 7: Advanced features such as Lighting schedules etc. Advanced features are provided to automate light controls in order to save energy and for your convenience. The Multi Dimmer has an additional feature to add and remove other dimmers in a group. These features are all configured in the dimmer settings screen as shown below.
6. Blinking/Flickering Lights: Dimmable bulbs only work properly with these solid-state dimmers. Most CFL bulbs are not dimmable and also first generation of LED’s may not be dimmable. Please ensure that your bulb is dimmable. Using non-dimmable bulbs with smart dimmers may induce noise on the light circuitry and the dimmer may not behave properly. For further help contact us FCC caution This device complies with part 15 of the FCC Rules.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help. warning for Mobile device: *ThisRFequipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.