Instruction Manual

www.toughcountry.com

INSTALLATION INSTRUCTIONS

Tough Country Products

1101 N. Blue Creek Rd

El Campo, TX 77437

Phone: 1-877-44TOUGH

Fax: 979-543-7209

2017-2022 Ford F250-F350

Traditional Rear

TB2017FRSSM

Tools Needed:

Ratchet

¾” Socket

¾” Wrench

13mm Wrench

21mm Socket

Bumper Removal Instructions:

1. Unplug 7way plug

2. If equipped with rear sensors, disconnect wiring harness and remove from factory bumper after

bumper has been removed from truck

*Do not pull on rear sensor from behind*

3. Disconnect all wiring from factory rear bumper

4. Using 21mm socket remove bumper mounting bolts

5. Remove 2-13mm bolts from center of receiver and remove factory bumper

6. With a 21mm socket remove L shaped brackets from frame

Installation of Tough Country Replacement Bumper:

1. Position support bracket on the outside of frame, with the l facing outward, with factory hardware and

provided bolts

*Hand tighten bolts*

PAGE 1
INSTALLATION INSTRUCTIONS Tough Country Products 1101 N. Blue Creek Rd El Campo, TX 77437 Phone: 1-877-44TOUGH Fax: 979-543-7209 2017-2022 Ford F250-F350 Traditional Rear TB2017FRSSM Tools Needed: Ratchet 13mm Wrench ¾” Socket 21mm Socket ¾” Wrench Bumper Removal Instructions: 1. Unplug 7way plug 2. If equipped with rear sensors, disconnect wiring harness and remove from factory bumper after bumper has been removed from truck *Do not pull on rear sensor from behind* 3.
PAGE 2
. Install bumper onto brackets with provided hardware and hand tighten only 3. Align and adjust to correct placement and tighten securely 4. If equipped with rear sensors, use small screwdriver to open retainer slightly and push sensor through retainer from the front side of the sensor 5. To remove the sensor sleeves, use the small screwdriver to depress the 4 retainers on each sleeve and gently push through *Keep position of sensors sleeves as holes are sensor sleeve specific* 6.