Operation Manual

T12002 Vitablend Blender
10
www.towerhousewares.co.uk
CARE AND CLEANING
Remove plug from the mains socket, and allow the appliance to cool down
before cleaning.
Do not immerse the motor unit of the appliance in water and make sure no
water enters the appliance.
Clean the motor unit by wiping it with a damp cloth. A little detergent can be
added if the appliance is heavily soiled.
Do not use scouring pads, steel wool or any form of strong solvents or abrasive
cleaning agents to clean the appliance, as they may damage the outside
surfaces of the appliance.
The beaker, rings, lids and the cutter can be washed using detergent and are all
dishwasher proof. Be careful if you wash the cutter by hand, as the blades are
extremely sharp.
If the cutter is not properly attached, liquid may seep out into the internal part of
the base unit. This may also be removed using a slightly dampened cloth and
a little detergent. Check that the motor section is thoroughly dry inside before
using the appliance again after cleaning.
Inside the blade unit is a plastic sealing ring, which may become loose when the
unit is put through a dishwasher. Therefore, please check that the sealing ring is
still in place when you remove the blade unit from the dishwasher
IMPORTANT! Allow to dry fully after cleaning before using again. Do
not use the appliance if damp. Ensure the appliance is completely clean
and dry before storing.
Storage
To store your appliance:
1. Unplug power cord from the power outlet and clean as above.
2. Allow the appliance to dry fully.
3. It’s good practice that the 2 blades are each attached to a cup. This will
prevent the blades from being misplaced and reduce cutting hazards.
4. Store on a flat, dry level surface out of reach of children.