Operation Manual

Safety and Instruction Manual
7
Helpline: [phone]
USING YOUR APPLIANCE:
Assembling the glass lid
• Screw and assemble the plastic vented knob to the glass lid using the
supplied screw
Connecting the unit
• Connect the temperature regulator to the base of unit. Make sure that
the plug is connected properly.
• Set the temperature regulator to heat level “0”.
• Connect the plug to a socket.
ATTENTION: Do not use a multiple outlet strip or extension cable.
Preparing food
• Brush the multi-cooker with a little cooking oil.
• Set the temperature regulator to the required heat level.
• The control lamp will light up to show that the unit is ready for use (ON).
• It takes approximately 5 -10 minutes to heat up the unit.
• Once the control lamp goes out you can then start cooking the food.
• If the food is completely done, you can adjust the temperature to lower
or “0” heat level.
Using the cover
• Use the glass cover where possible when cooking all food types.
The cover prevents smells from escaping and reduces cooking time.
• The lid knob is designed with vents all the way round. It allows
condensation from the steam and also prevents the build up the dirt
and grease.
NOTE: The glass cover has a vent through which hot steam can escape!
After use
• Set the temperature regulator to heat level “0” and pull the plug out
of the mains socket.
• Allow the unit to cool down thoroughly before cleaning it.
N OTE:
Always remove the plug from the mains supply and wait to cool before
Always remove the plug from the mains supply before cleaning the
appliance.
The exterior of the appliance should be cleaned, if necessary, with a
slightly damp cloth without additives.
Carefully clean the unit and cover.
Do not use any aggressive detergents, brushes with metal or nylon bristles
or sharp objects such as knives or spatulas for cleaning the unit.
Avoid damaging the non-stick coating.
Always dry the unit thoroughly after cleaning it.