Installation Instructions

TowerIQ, Inc | 1609 Park 370 Place, Hazelwood, MO 63042| 844‐626‐7638 | cs‐guardian@tower‐iq.com

4.3 Interior Antennas

Mount the interior antenna(s) in the location(s) you selected when planning. Follow all instructions included with the antenna(s)to ensure

the installation(s) are done properly.

Here are a few reminders and essential steps:

• Dome antennas are mounted on the ceiling as close to the center of the desired coverage area as possible, domed(convex)

side pointing down.

• Flat panel antennas should be wall‐mounted as close as possible to the center of the wall, or at one end of long narrow space.

• Mount the antenna.

• Connect a length of cable to the antenna and tighten until hand‐tight.

• If you are installing multiple antennas, run the cable to the splitter location and connect the cable to one of the outputs on the

splitter.

• Connect another length of cable to the input side of the splitter (if used) and run this cable to the BDA location.

• It is important to keep the cable runs equal or use taps to ensure a harmonious install.

CAUTION: VERIFY THAT ALL INTERIOR ANTENNAS MEET THESEPARATION

REQUIREMENTS DESCRIBED IN THE PREVIOUS CHAPTER, AND THAT NO

ANTENNA IS AIMED TOWARD THEEXTERIOR ANTENNA.

CAUTION: DO NOT CONNECT AN INTERIOR ANTENNA TO THESPLITTER INPUT.