Installation Instructions

TowerIQ, Inc | 1609 Park 370 Place, Hazelwood, MO 63042| 844‐626‐7638 | cs‐guardian@tower‐iq.com

4.4 Mounting the BDA

Mount the GuardianB as follows:

• Verify that the selected location meets all criteria described in the previous chapter.

• Mount a 24 inch x 24 inch x 3⁄4 inch thick sheet of plywood on top of sheetrock, secured into wall studs where the Type 4 housing

is to be placed. The plywood should be flush against wall.

• Once the plywood is secure, attach the

Type 4 housing to the plywood base using the screws provided. In most

installations, the housing will be oriented, so the I/O ports are facing down.

• Connect the outdoor antenna cable to the signal booster connector port marked OUTSIDE and tighten the connection.

• Connect the outdoor antenna cable to the signal booster connector port marked INSIDE and tighten the connection.

CAUTION: DO NOT POWER ON THE BDA UNTIL INSTRUCTEDTO DO SO.

CAUTION: NEVER POWER ON THE BDA WHEN ANY ANTENNASARE

DISCONNECTED AS THIS COULD DAMAGE THE BDA.