Product Card

TSB-190327-0366 3
Factory Default Settings
Master Code: 123456
Penalty Time: 1 minute 30 seconds after 5 invalid entries
Dual Verification Mode: Disabled
Sound: Enabled
Handing Information - IMPORTANT
Handing must be set before programming lockset. It will not allow you to program lockset until handing is set.
Steps
1. Confirm lockset is in locked position, meaning deadbolt is extended.
2. Confirm handing indicator on battery tray is in correct position – RH (Right Hand) or LH (Left Hand).
3. Confirm lock spindle is in correct position – Horizonal Position for RH or Vertical Position for LH.
4. Wake up keypad by swiping or tapping surface, and press “0” key followed by “#” key.
After pressing “0” then “#”, deadbolt will retract then extend again. This means lockset handing is set.
If handing does not set, see Steps 1-3, then see Reset Lock without Master Code on page 9. Finally, see Step 4.